If you want to install drywall on your own, then you must know more about drywall installation. This will help avoid the common mistakes that individuals make when hanging the drywall. Like any other job, there are the right and wrong ways of getting things done. Here are tips that can help you out.  

1. Hang the drywall vertically.  

It’s important to have adequate edge support to the drywall’s framework structure is necessary to install a strong wall. However, the inner corners are usually inadequate or completely absent in drywall, thus rendering them difficult to fasten. To fix this, check the frame before mounting the drywall. Ensure there’s at least one support framework in there. If there aren’t any, some posts in addition to whatever framing is installed.  

Inspect the topmost part of the wall that runs along with the ceiling’s framing. Blocking is normally fixed to the topmost plate of the drywall during the framing process. However, this is also the type that is frequently missing. Drive the screws at an angle if there’s no room to swing a hammer.  

2. Mark the framing locations.  

You will find it difficult to correctly place the screws if you fail to mark the locations of the framing before covering them with the drywall. Make these parts and use a pencil to put a line on the sheet for the correct positioning of screws. You can quickly, easily, and accurately drive the screws. By marking the frame, you won’t waste time cutting screws.  

Mark the position of the joists on the topmost layer of the framing. Mark on the concrete the middle part of every stud. Take note of the special framing so that you’ll know exactly where to put the screws after it has been covered with the drywall. Mark it with the use of a pencil on the ceiling before installing the drywall and after hanging the ceiling.  

3. Remove the tapered edges.  

Hanging a drywall sheet with tapered edges along the outer corners can be difficult since the corner will be too low for the joint compound to cover. The key is to position the edges along the other corner for seamless installation.   

4. Fit before fastening.   

You will often find that you need to cut the drywall to accommodate an electrical outlet if you don’t fit and test the boards yet. A common mistake is screwing the drywall onto the frames and then splitting it near the electrical box. While this will work, it requires extra patching time. The way to solve this issue is to test the fit before pressing the drywall tightly onto the wall.  

Keep the drywall in place after the holes in your drywall board have been carefully measured and cut. If it fits good, fasten the drywall using screws along the upper edges or far from the electrical outlets. Cut the excess drywall around the edges of the box using a utility knife until the drywall easily slides over the electrical outlet boxes. If there’s any problem with the installation, hire the best in drywall repair Reno to handle the matter.